[ << ] | [ < ] | [ Up ] | [ > ] | [ >> ] | [Top] | [Contents] | [Index] | [ ? ] |
3.17.30 PDP-11 Options
These options are defined for the PDP-11:
-mfpu
-
Use hardware FPP floating point. This is the default. (FIS floating point on the PDP-11/40 is not supported.)
-msoft-float
-
Do not use hardware floating point.
-mac0
-
Return floating-point results in ac0 (fr0 in Unix assembler syntax).
-mno-ac0
-
Return floating-point results in memory. This is the default.
-m40
-
Generate code for a PDP-11/40.
-m45
-
Generate code for a PDP-11/45. This is the default.
-m10
-
Generate code for a PDP-11/10.
-mbcopy-builtin
-
Use inline
movmemhi
patterns for copying memory. This is the default. -mbcopy
-
Do not use inline
movmemhi
patterns for copying memory. -mint16
-mno-int32
-
Use 16-bit
int
. This is the default. -mint32
-mno-int16
-
Use 32-bit
int
. -mfloat64
-mno-float32
-
Use 64-bit
float
. This is the default. -mfloat32
-mno-float64
-
Use 32-bit
float
. -mabshi
-
Use
abshi2
pattern. This is the default. -mno-abshi
-
Do not use
abshi2
pattern. -mbranch-expensive
-
Pretend that branches are expensive. This is for experimenting with code generation only.
-mbranch-cheap
-
Do not pretend that branches are expensive. This is the default.
-munix-asm
-
Use Unix assembler syntax. This is the default when configured for ‘pdp11-*-bsd’.
-mdec-asm
-
Use DEC assembler syntax. This is the default when configured for any PDP-11 target other than ‘pdp11-*-bsd’.
[ << ] | [ < ] | [ Up ] | [ > ] | [ >> ] | [Top] | [Contents] | [Index] | [ ? ] |
This document was generated on October 19, 2013 using texi2html 5.0.