manpagez: man pages & more
info gcc
Home | html | info | man
[ << ] [ < ] [ Up ] [ > ] [ >> ]         [Top] [Contents] [Index] [ ? ]

3.17.14 H8/300 Options

These ‘-m’ options are defined for the H8/300 implementations:

-mrelax

Shorten some address references at link time, when possible; uses the linker option ‘-relax’. See ld and the H8/300 in Using ld, for a fuller description.

-mh

Generate code for the H8/300H.

-ms

Generate code for the H8S.

-mn

Generate code for the H8S and H8/300H in the normal mode. This switch must be used either with ‘-mh’ or ‘-ms’.

-ms2600

Generate code for the H8S/2600. This switch must be used with ‘-ms’.

-mexr

Extended registers are stored on stack before execution of function with monitor attribute. Default option is ‘-mexr’. This option is valid only for H8S targets.

-mno-exr

Extended registers are not stored on stack before execution of function with monitor attribute. Default option is ‘-mno-exr’. This option is valid only for H8S targets.

-mint32

Make int data 32 bits by default.

-malign-300

On the H8/300H and H8S, use the same alignment rules as for the H8/300. The default for the H8/300H and H8S is to align longs and floats on 4-byte boundaries. ‘-malign-300’ causes them to be aligned on 2-byte boundaries. This option has no effect on the H8/300.


[ << ] [ < ] [ Up ] [ > ] [ >> ]         [Top] [Contents] [Index] [ ? ]

This document was generated on October 19, 2013 using texi2html 5.0.

© manpagez.com 2000-2025
Individual documents may contain additional copyright information.